Product Description
4 Color Process Inks allow the printer to achieve a full range of colors using a minimum number of inks.
For direct printing on white, 100% cotton garments.
A Low Bleed (LB) Underlay is necessary for Cotton/Polyester, Acrylic & Polyester garments
- Bleed Resistance: None
- Opacity: None
- Artwork: Separations are critical to the success of printing these inks.
- Mesh: 280 and up
- Stencil: Any direct emulsion or capillary film.
- Squeegee Hardness & Angle: Medium to hard at a 45 degree angle.
- Modifications:
- To reduce viscosity use Curable Reducer (I10-9906)
- To extend color use Soft-hand Base (I10-0111).
- Flashing: Not recommended.
- Fusion/Curing:325 F/160 C for 1 to 1 ½ minutes. Oven temperature can be increased and dwell time decreased.
- Heat presses: 390 F/195 C for 8 seconds.
- Storage: Ideally 65 to 80 F. Keep out of direct sunlight.
- Wash-up: Any plastisol cleaner.
Refer to this Tech Sheet for further recommendations for working with Process Inks.
Special Notes:
PVC inks are thermoplastic compounds that require heat to fuse or cure.
If ink rubs off on a white cloth or cracks, temperature and/or dwell time should be increased.
Do not dry clean
Always test on fabric to be printed.
